小安哥

I am wondering if we can use a 辣雞 to 辣 the at168 out and then "fly-wire" to a breadboard for easy exchange of at168 chips

薯餅v.v

原帖由 小安哥 於 2009-6-9 20:34 發表
I am wondering if we can use a 辣雞 to 辣 the at168 out and then "fly-wire" to a breadboard for easy exchange of at168 chips

吾洗辣
焊著既只係個座
用一字"派"就可以整佢出黎

小安哥

原帖由 薯餅v.v 於 2009-6-9 20:40 發表

吾洗辣
焊著既只係個座
用一字"派"就可以整佢出黎

i see
thanks for your answering

小安哥

I would like to ask one more question: how to connect the modules directly to the at168 after i finished the whole job to make it runs separately without Arduino Duemilanove and shields

qazwsxedcrfv000

原帖由 TELAMON 於 2009-6-9 17:55 發表

如果兩個都插曬
會唔會自動轉換
usb for date
dc input for電源

It should be okay

薯餅v.v

原帖由 小安哥 於 2009-6-9 20:43 發表
I would like to ask one more question: how to connect the modules directly to the at168 after i finished the whole job to make it runs separately without Arduino Duemilanove and shields

go and check diy專區

薯餅v.v

原帖由 qazwsxedcrfv000 於 2009-6-9 21:08 發表


It should be okay

有冇考慮加常用元件包?

qazwsxedcrfv000

原帖由 薯餅v.v 於 2009-6-9 21:12 發表

有冇考慮加常用元件包?

You mean resister pack and capacitor pack??

小安哥

i suggest adding at168 or at328 chips without bootloader to lower the cost of chips for people who own the USBtinyisp

薯餅v.v

原帖由 小安哥 於 2009-6-9 21:33 發表
i suggest adding at168 or at328 chips without bootloader to lower the cost of chips for people who own the USBtinyisp

我諗應該係想少D 郵費..係番同一問賣ARDUINO 訂
平少少吾會平好多  最少20粒先有得平