TinyBoy 2

fred2088

Rank: 3 Rank: 3 Rank: 3

731^# 跳轉到 »

發表於 2018-12-23 00:02 | 只看該作者

本帖最後由 fred2088 於 2018-12-23 00:25 編輯

回覆 730# fred2088

Merry Christmas 2018 !!!
https://www.thingiverse.com/thing:2694509

IMG_6305.JPG (75.71 KB)

TOP

fred2088

進階會員

Rank: 3 Rank: 3 Rank: 3

732^#

發表於 2018-12-23 18:53 | 只看該作者

回覆 731# fred2088

InnoCentre : 3D Printing workshop by SCMP ...

IMG_6314.JPG (67.96 KB)

IMG_6313.JPG (58.03 KB)

IMG_6312.JPG (60.13 KB)

IMG_6311.JPG (59.67 KB)

IMG_6309.JPG (63.46 KB)

IMG_6308.JPG (66.77 KB)

TOP

fred2088

進階會員

Rank: 3 Rank: 3 Rank: 3

733^#

發表於 2018-12-24 07:53 | 只看該作者

本帖最後由 fred2088 於 2018-12-24 07:58 編輯

回覆 732# fred2088

用 ESP8266 測試 20x WS2812 成品,  (10 上進度燈, 10 下機內照明 ...)
Marlin 2.x enabled
Configuration.h
----------------------------------------------------------------------------------------------------------------
#if ENABLED(NEOPIXEL_LED)
  #define NEOPIXEL_TYPE NEO_RGB // NEO_GRBW / NEO_GRBW - four/three channel driver type (defined in Adafruit_NeoPixel.h)
  #if ENABLED(TINYBOY_RE20)
   #define NEOPIXEL_PIN  44    // LED driving pin on motherboard 4 => D4 (EXP2-5 on Printrboard) / 30 => PC7 (EXP3-13 on Rumba)
  #else
#define NEOPIXEL_PIN 4       // LED driving pin on motherboard 4 => D4 (EXP2-5 on Printrboard) / 30 => PC7 (EXP3-13 on Rumba)
  #endif
  #define NEOPIXEL_PIXELS 20    // Number of LEDs in the strip
  #define NEOPIXEL_IS_SEQUENTIAL    // Sequential display for temperature change - LED by LED. Disable to change all LEDs at once.
  #define NEOPIXEL_BRIGHTNESS 100 // Initial brightness (0-255)
//  #define NEOPIXEL_STARTUP_TEST    // Cycle through colors at startup
#endif
-----------------------------------------------------------------------------------------------------------------