fred2088

回復 499 #palpatrick

看來要你出山

via HKEPC Reader for Android

joeyCC

Dear C'hing,  my Tinyboy2 works for me 6months already.  Recently, encountered "Thermal run away" when printing for a few prints.  Power off then on, print again sometime works, sometime not.  Today, when boot up it got "Err: MINTEMP" and stop doing anything. Click/push button no response.   
Connect USB to PC Repeiter Host, it shows the same error "MINTEMP  triggered, system stopped! Heater_ID:0"
I think the thermistor connection may be bad, I took it out that look good, meter check connector are good too.  Where I can find/buy a spare TinyBoy2 thermistor for a try?

Thanks, thanks

fred2088

回覆 500# apple_100


    新的1.1bugfix 未放上去...

fred2088

回覆 502# joeyCC


    拿部機 去 KK 處 看看 ...

palpatrick

回覆 501# fred2088


   暫時無咩時間攪！現在想不勞而獲多D！

apple_100

回覆 503# fred2088


    其實我想知點用，見入面係個arduino，唔知點裝

fred2088

回覆 506# apple_100


    你的主板應已寫入 Firmware ...

lunlun

想問下可否share 最早期上砌機班嗰批L16嘅 Marlin Firmware
底板係 Tinyboy2 MKS Base v1.0
其實主要想知個LED 設定參數, 係Marlin要點set

下載 (41.71 KB)

2017-5-9 21:43

Thanks

fred2088

回覆 508# lunlun


    docs.tinyboy.net

fred2088

[attach]1981514[/attach][attach]1981514[/attach]回覆 509# fred2088


    新 print Mat ...

下載 (76.37 KB)

2017-5-9 23:03