xo_ox

如果要印ABS/PC, X1 好啲

minki

如果要印ABS/PC, X1 好啲
xo_ox 發表於 2023-5-25 17:49

P1P印到ABS...不過PC真係要X1C

xo_ox

P1P印到ABS...不過PC真係要X1C
minki 發表於 2023-5-26 11:19

   
ABS , PC 有甚麼分？除了氣味？
現在我一般都係印PC無乜味⋯⋯

super_fatman

PC 比 ABS 會產出更多微粒. Polycarbonate 有機會含有 BPA ?

Word to the wise on safety. It seems that PC produces a lot of micro-fine particles, more so than ABS. These particles accumulate on the underside of the print-head. If they accumulate there, then they are likely in the air as well. Work in a well-ventilated area or install some ventilation. On a side note, try not to stare too closely to the object being printed. After a while it stings the eyes.

https://reprap.org/wiki/Polycarbonate#Safety_Issues

minki

ABS , PC 有甚麼分？除了氣味？
現在我一般都係印PC無乜味⋯⋯
xo_ox 發表於 2023-5-26 21:12

PC印溫同硬度都高過ABS....上X1C好O的....

xo_ox

PC印溫同硬度都高過ABS....上X1C好O的....
minki 發表於 2023-5-28 09:09

   
買的PC料，都240-260,床90-100， 無封箱都印到，又沒甚麽味！

minki

買的PC料，都240-260,床90-100， 無封箱都印到，又沒甚麽味！
xo_ox 發表於 2023-5-29 18:42

唔係味...係收縮同離底層

tszhoki

想618入部p1p
想請問係咪有大陸電話就ok?or要行vpn

xo_ox

想618入部p1p
想請問係咪有大陸電話就ok?or要行vpn
tszhoki 發表於 2023-5-30 03:39

    係囉又平了，如果手上不是有太多機，都相買一個

tszhoki

回覆 49# xo_ox


    我見有人話vpn開完都係會封綁唔到