postmaster

各品牌唔使緊張喎 , mikrotik 唔會啱99% 家用市場 ，只有一小圈子組別高楷專業用家自用。

publicuser

太麻煩，唔啱我

张无忌

回覆 151# postmaster

不同人有不同的需要，如果要提升Networking的功力（VPN，VLAN等），MikroTik RouterOS，又便宜，功能有强大！如果没有学习劲头，那么购买一般的router算了！

navimak

剛升級去6.41.3，wifi同wan/lan throughput 都差好多，downgrade番原本嘅版本6.40.5正常返。RC版冇試過。

postmaster

絕對同意。之前去開歐州旅行，入了自用


當時還想入 OmniTIK 5 ac 放在後花園用。

postmaster

回覆 155# navimak


如有問題，應該報告給 mikrotik  support@mikrotik.com

我通常測試新玩具時,  wan 口接上用 自己的 iperf3 server， 數據較準確。

3KingDom

回覆 144# mc16888

回覆 149# navimak

Regarding Wifi, try go to interface-> wlan1 -> choose advance mode -> then ‘Tx Power’ Tab will turn up -> Tx Power Mode -> card rates then Tx Power -> 17dBm
Then you can has a test again to see got any improvement or not.

For HOME use “Tx Power mode” should be set to “card rates”, if it is allowed. Some new wifi chip may not allow you to use "card rates" mode  in mikrotik.

Tx Power can fine tune later according to your own situation.

I have RB751G-2HnD in 2012 it has 1000mW wifi and default use this figure. Hap Ac2 have 2.4G~=250mW, 5G~=120mW. ( 17dbm ~=50mW). Now I use it as an AP with my 750Gr3 hEX.

I got ~ 33-37db signal when ~2m away from my RB751G-2HnD.

https://wiki.mikrotik.com/wiki/Manual:Wireless_FAQ

postmaster

https://habrahabr.ru/post/351044/
大家有冇出現硬件貨不對辩情況 ?
RAM size !!
https://habrastorage.org/webt/p2/v8/ma/p2v8makgd7uqlf4ljwhp17jqiau.jpeg

navimak

回覆 159# postmaster


    你意思由128MB 加到256MB?