cheetah

[部機冇電到=unplug], I always unplug the power, no problem whatsoever at all. no need any "重新搜過any電視頻道". Say the previous [Channel 85] before power unplug even stays after power on reload. The price is 23 seconds.

cheetah

原帖由 cheetah 於 2009-9-14 10:42 發表


Answer:-
- probably no, 長 standby mode 部機便可以
- 用remote 熄機 = standby mode
- 用手操作熄機身掣 = standby mode
- 連 wall socket power 掣都熄埋 = off mode, it can do nothing then.

CORRECTION HERE (just tryout FILE PVR TIMER):-

"預校錄影是否要長著部機先至可以" u knew the magic, actually you r 98% right, the answer is, however:- "預校日子時間錄影後熄機部機會自動著翻機"......

Once after "File->Timer->Enable->Set time->Off to standby" etc setup, then no matter 用 remote 熄機 or 用手操作熄機身掣 to standby mode, within minutes, the machine will wake itself up, reload the previous channel, then switch to yr specified channel set upon yr specified time set.

A strange arrangement here, no idea whether it is because of using USB flash or Timeset mode.......

Solution for the time being:- OFF yr TV set in case u hv set the PVR timer and expecting silence thereafter, otherwise the noise may scare the shxt out of u all of a sudden......

[ 本帖最後由 cheetah 於 2009-9-18 09:16 編輯 ]