作者: 小喇喇 時間: 2009-12-24 14:07 標題: Little Boy Clarkdale i3 540 + Asus P7P55D Deluxe [LN2, 5.9G]
To continue the test to the little boy Clarkdale i3 540,
Today, change back to P7P55D Deluxe today, pump it to 1.9Vfor my little boy i3 540.....
5796Mhz, 3D03, 148296marks, bclk limited.....
5866MHz for SPI 1M, 7.098s, can't break 7sec wall....
Highest can be validated is 5910MHz, but I use 1.52.2 CPU-Z, it can't be validated now...ahhaha....never mind...
CBB at -110C....
[ 本帖最後由 小喇喇 於 2009-12-24 14:15 編輯 ]
作者: 3R1C 時間: 2009-12-24 14:11
哇,強呀天天
快d破super pi 1m 6s
作者: 林不肥 時間: 2009-12-24 14:17
仲上埋256BCLK
勁過SABERTOOTH
如果SABERTOOTH BIOS有得玩2.1V就..
作者: 小喇喇 時間: 2009-12-24 14:21
原帖由 林不肥 於 2009-12-24 14:17 發表
仲上埋256BCLK
勁過SABERTOOTH
如果SABERTOOTH BIOS有得玩2.1V就..
Highest bclk I get with X23 is 257 for P7P55D Deluxe, 2MHz above Sabertooth, they are almost the same as I use 1.6V Vtt (as I need to run 3D) for my Deluxe, Sabertooth I just use 1.475V for Validation only. Validation is much easier than 3D running....
[ 本帖最後由 小喇喇 於 2009-12-24 14:22 編輯 ]
作者: 林不肥 時間: 2009-12-24 15:37 標題: 回覆 4# 的帖子
X2
過埋3D MK滿足感大好多..
作者: chiushing01 時間: 2009-12-25 08:00
原帖由 林不肥 於 2009-12-24 15:37 發表
X2
過埋3D MK滿足感大好多..
OC都有不同目標的測試
作者: Mad222 時間: 2009-12-26 13:19
原帖由 小喇喇 於 2009-12-24 14:21 發表
Highest bclk I get with X23 is 257 for P7P55D Deluxe, 2MHz above Sabertooth, they are almost the same as I use 1.6V Vtt (as I need to run 3D) for my Deluxe, Sabertooth I just use 1.475V for Validati ...
Wow....the IMC volt is 1.6v for 257 BCLK ?!:funk:
Tried below 1.6V ???
Both my 750/860 need below 1.42v for max. 253BCLK