作者: podiff 時間: 2012-5-16 11:49 標題: 特急求教!!! GIGA 板問題
岩岩入左塊GA-Z77X-UD5H ,
插左兩塊GTX670 + 一塊OCZ RevoDrive 3
但部機完全認唔到塊OCZ RevoDrive 3,
已經BOOT 左好幾次, 都仲認唔到，有無人知係咩事?
各位ching 請幫幫手ORZ
作者: Summer 時間: 2012-5-16 12:10
OCZ RevoDrive 3 100%ｗｏｒｋ？
作者: podiff 時間: 2012-5-16 12:28
100% WORK! 用過部舊機試過, 都認到, 無問題
作者: chowty 時間: 2012-5-16 13:01
係咪冇hdd? 可能張板認唔到張ocz 做hard disk
作者: star_hk 時間: 2012-5-16 13:11
BIOS入面認唔認到先
作者: O人 時間: 2012-5-16 13:14
提示: 作者被禁止或刪除 內容自動屏蔽
作者: podiff 時間: 2012-5-16 13:40
回復 5# star_hk
BIOS 認唔到 ，
應該唔關DRIVER事??
作者: chowjerrymk 時間: 2012-5-16 15:39
I dont think you have enough PCIe bandwidth on this Z77 chipset
作者: peterma 時間: 2012-5-16 15:48
下面資料來自技嘉網站GA-Z77X-UD5H
----------------------------------------------------------------------------------
1 x PCI Express x16 slot, running at x16 (PCIEX16)
* For optimum performance, if only one PCI Express graphics card is to be installed, be sure to install it in the PCIEX16 slot.
1 x PCI Express x16 slot, running at x8 (PCIEX8)
* The PCIEX8 slot shares bandwidth with the PCIEX16 slot. When the PCIEX8 slot is populated, the PCIEX16 slot will operate at up to x8 mode.
1 x PCI Express x16 slot, running at x4 (PCIEX4)
* The PCIEX4 slot is available only when an Intel 22nm (Ivy Bridge) CPU is installed.
* The PCIEX4 slot shares bandwidth with the PCIEX8 and PCIEX16 slots. When the PCIEX4 slot is populated, the PCIEX16 slot will operate at up to x8 mode and the PCIEX8 will operate at up to x4 mode.
(The PCIEX16, PCIEX8 and PCIEX4 slots conform to PCI Express 3.0 standard.)
* PCIE Gen.3 is dependent on CPU and expansion card compatibility.
作者: podiff 時間: 2012-5-16 16:29
下
甘即係 PCIEX16 + X8 + X4 係假既?? GIGA 咩事R
作者: Pioneer06 時間: 2012-5-16 18:41
下 甘即係 PCIEX16 + X8 + X4 係假既??
GIGA 咩事R
podiff 發表於 2012-5-16 16:29
It is not the problem of Gigabyte about the setting , all Z77 board is same about the configuration. If you don't understand, please review the technical paper for architecture of Z77 Chipset .
BTW, I don't think it is the problem of PCIE bandwidth , from the page :
http://www.ocztechnology.com/ocz-revodrive-pci-express-ssd.html
It is interface with x4 , even it run at PCIE 2.0 , it should have more than enough bandwidth for the data transfer. (2.0 bandwidth is 500MB/s per lane)
作者: chowty 時間: 2012-5-16 19:54
佢係認唔到, 應該唔關bandwith?
作者: podiff 時間: 2012-5-16 23:36
試左拎起左2張GTX670, 淨係插OCZ RevoDrive 3 終於認到, 一切正常! 仲諗住好野終於搞店!
但之後插返果2張GTX670 同 OCZ 一齊又係咪, 又認唔到 OCZ卡....
甘即係GIGA板既BRANDWIDTH 問題??
作者: Evangeline 時間: 2012-5-16 23:42
你用乜U?
作者: 寂寞的FSY 時間: 2012-5-16 23:47
試左拎起左2張GTX670, 淨係插OCZ RevoDrive 3 終於認到, 一切正常! 仲諗住好野終於搞店!
但之後插返果2張GT ...
podiff 發表於 2012-5-16 11:36 PM
淨係插一張有無問題?
同埋插落邊組PCI-E槽?
作者: podiff 時間: 2012-5-16 23:54
回復 14# Evangeline
買左粒新i7-3770K玩... 點都唔關粒U事掛??
作者: podiff 時間: 2012-5-16 23:57
淨係插一張有無問題?
同埋插落邊組PCI-E槽?
寂寞的FSY 發表於 2012-5-16 23:47
淨係插一張, 插左去PCIEX16果條槽就無問題
作者: Evangeline 時間: 2012-5-16 23:57
last PCI-E only work if you use ivy bridge...but you are using ivy bridge now...
作者: 寂寞的FSY 時間: 2012-5-17 00:18
last PCI-E only work if you use ivy bridge...but you are using ivy bridge now...
Evangeline 發表於 2012-5-16 11:57 PM
有點奇怪
正因為Z77的PCI-E x4唔係從Z77晶片組抽出來，理應插晒卡都唔會影響其他SATA/USB接口，除非係設計時出錯啦
作者: Pioneer06 時間: 2012-5-17 00:56
Would you please try whether it is working or not if plug 1 GTX670 to PCIEx16 and the OCZ to the PCIEx8 ?
And also the BIOS version ?
P.S. : The another GTX670 , don't plug to the system.
作者: podiff 時間: 2012-5-17 12:32
好, 等放工返去CHECK~
作者: podiff 時間: 2012-5-18 01:42
Would you please try whether it is working or not if plug 1 GTX670 to PCIEx16 and the OCZ to the PCI ...
Pioneer06 發表於 2012-5-17 00:56
都試左... 一張GTX670 喺PCIE x16+ OCZ 喺PCIE x8 都唔得.... XXXXX
作者: Pioneer06 時間: 2012-5-18 11:16
OK , seems you are not alone, the OCZ is quite troublesome .....
http://www.tomshardware.com/forum/281404-32-optimize-revodrive
http://www.ocztechnology.com/dis ... revodrive_moboguide
BTW, another try :
OCZ to PCIEx16 , GTX670 to PCIEx8, PCIEx4 leave blank.
If it works , it should be the BIOS issue. If not, try to disable as much as Harddisk related stuff in the BIOS and try again.
作者: superas 時間: 2012-5-18 13:10
下 甘即係 PCIEX16 + X8 + X4 係假既??
GIGA 咩事R
podiff 發表於 2012-5-16 16:29
樓主都幾浪費,唔理認唔認到張卡, 就算認到,
張GIGA 若果插3張卡, GIGA 寫到明, 行到盡都係X8+X4+X4. 唔會係X16+X8 +X4
你雙張GTX670 都無咩用，又行唔到SLI
其實GIGA 寫到明，都唔算係呃
作者: 冷心心 時間: 2012-5-18 13:52
本帖最後由 冷心心 於 2012-5-18 13:55 編輯
都試左... 一張GTX670 喺PCIE x16+ OCZ 喺PCIE x8 都唔得.... XXXXX
podiff 發表於 2012-5-18 01:42
你怎插啊!張OCZ RevoDrive 3只可插最尾那個PCIEx16,
670插第一個pciex16 ,而那張wifi pcie要不插,這樣試下,
作者: podiff 時間: 2012-5-21 00:26
:xd終於搞店!!
作者: podiff 時間: 2012-5-21 00:30
樓主都幾浪費,唔理認唔認到張卡, 就算認到,
張GIGA 若果插3張卡, GIGA 寫到明, 行到盡都係X8+X4+X4. 唔 ...
superas 發表於 2012-5-18 13:10
真係俾佢FAKE左....點算.... $2XXX 買張卡都甘
認真想問問, 係GIGA 係甘, 定所有牌子都係甘, 有無邊張板係真係可以用到 X8+X8+X4???
作者: 喬芬‧費曼高 時間: 2012-5-21 04:51
提示: 作者被禁止或刪除 內容自動屏蔽
作者: superas 時間: 2012-5-21 16:29
真係俾佢FAKE左....點算.... $2XXX 買張卡都甘
認真想問問, 係GIGA 係甘, 定所有 ...
podiff 發表於 2012-5-21 00:30
ASROCK 都唔會有事. 揀中GIGA係你黑仔
換過板啦! Fatal1ty Z77 Professional 又平D 又可以884~
作者: 寂寞的FSY 時間: 2012-5-21 18:14
真係俾佢FAKE左....點算.... $2XXX 買張卡都甘
認真想問問, 係GIGA 係甘, 定所有 ...
podiff 發表於 2012-5-21 12:30 AM
如果計埋從南橋晶片「抽取」頻寬，現時許多Z68同Z77都係呢個設計
如果唔計就無了，因為LGA 1155 CPU只提供x16 PCI-E頻寬
作者: 寂寞的FSY 時間: 2012-5-21 18:33
ASROCK 都唔會有事. 揀中GIGA係你黑仔
換過板啦! Fatal1ty Z77 Professional 又平D 又可以884~ ...
superas 發表於 2012-5-21 04:29 PM
行到884又唔會令到外接USB3、SATA3、LAN卡等裝置用唔到，咁先奇怪...
作者: mlc130104 時間: 2012-5-22 00:35
提示: 作者被禁止或刪除 內容自動屏蔽