作者: vc2010 時間: 2012-10-7 16:08 標題: gigabit switch for nas
不知道大家有什麼好推薦?
作者: melodyayaka 時間: 2012-10-7 16:13
blocking or non-blocking ?
my suggestion is just go for Cisco ... you cant go wrong with it
作者: vc2010 時間: 2012-10-8 03:05
回復 2# melodyayaka
non-blocking
SG300-10MP?有無review?
HP 1910/Dell PowerConnect 2808好唔好?
作者: melodyayaka 時間: 2012-10-8 18:31
回復 melodyayaka
non-blocking
SG300-10MP?有無review?
HP 1910/Dell PowerConnect 2808好唔好? ...
vc2010 發表於 2012-10-8 03:05
I dont see the reason not to buy Cisco ....
作者: KinChungE 時間: 2012-10-8 18:36
回復 melodyayaka
non-blocking
SG300-10MP?有無review?
HP 1910/Dell PowerConnect 2808好唔好? ...
vc2010 發表於 2012-10-8 03:05
1910唔係100M咩(單giga port)?
好似1810G先有Giga?
作者: GbE 時間: 2012-10-9 14:46
本帖最後由 GbE 於 2012-10-9 14:47 編輯
In fact, 推薦 depends on your requirement
作者: pockchop 時間: 2012-10-9 14:49
tp-link 1008d
8port giga
$2XX
作者: vc2010 時間: 2012-10-9 18:56
屋企用
諗住Network分開兩組管理(一組 set 晒192.168.0.xxx for data/ pc, 一組 set 晒10.0.0.xxx for storage/ nas)o唔ok?直接連線至家中的NAS會唔會有問題?屋企用會唔會一組set晒方便d?
pockchop ching
tp-link相較其他機種價錢平一截,會否影響表現/速度?長開24/7,隻switch嘈唔嘈,熱唔熱?
作者: kelvinwong0429 時間: 2012-10-9 18:59
回復 8# vc2010
vlan,5係部部consummer router行到
作者: GbE 時間: 2012-10-9 19:36
本帖最後由 GbE 於 2012-10-9 19:37 編輯
一組 set 晒192.168.0.xxx for data/ pc, 一組 set 晒10.0.0.xxx for storage/ nas ....
就以上 requirement, 睇唔到你有乜特別需要. 行 2 組 IP ( 2 subnet ), 其實可以係 same broadcast domain 內做 ( no VLAN need ) ....
如果介紹貴 Switch ( over $1500 ), 我覺得樓主用唔著 law
都係買隻 <$400 8-port Giga switch 算喇, 到你知道有乜需要先買個隻玩好了
作者: melodyayaka 時間: 2012-10-9 19:38
屋企用
諗住Network分開兩組管理(一組 set 晒192.168.0.xxx for data/ pc, 一組 set 晒10.0.0.xxx for st ...
vc2010 發表於 2012-10-9 18:56
you need a managed switch to create VLAN , most cheap GB switches are un-managed
作者: GbE 時間: 2012-10-9 20:24
HP 1910可能啱駛, 視乎你用唔用, 反而想知要幾 $$$$
Layer 3 services
• Address Resolution Protocol (ARP): determines the MAC address of another IP host in the same subnet; supports static ARPs; gratuitous ARP allows detection of duplicate IP addresses; proxy ARP allows normal ARP operation between subnets or when subnets are separated by a Layer 2 network
作者: pockchop 時間: 2012-10-10 00:48
回復 8# vc2010
我用緊tp-link 1008d幾好無乜問題唔噪不過我未用過貴野就真
作者: KinChungE 時間: 2012-10-10 01:55
1008D冇風扇, 冇可能嘈
作者: vc2010 時間: 2012-10-10 04:04
Melody-HP/Dell/Cisco 好用不過價錢又貴一截. 屋企用,要睇預算做人,要唔要用貴野?
Gbe ching-平地又好用,可以揀邊個?Hp1910 好似係 layer 2, 好似唔係 managed?
pockchop ching-Layer3+managed, tp-link o唔ok?
作者: 炎冬 時間: 2012-10-10 04:07
Melody-HP/Dell/Cisco 好用不過價錢又貴一截. 屋企用,要睇預算做人,要唔要用貴野?
Gbe ching-平地又好用,可 ...
vc2010 發表於 2012-10-10 04:04
1910是Layer 3 switch, 1810是Layer 2 switch, 2隻都是managed switch, 如有錯請輕輕的插..
作者: pockchop 時間: 2012-10-10 10:19
回復 15# vc2010
TP-link其他model我未用過, 個人感覺係好單薄...
作者: google 時間: 2012-10-10 10:39
How about Netgear GS108T?
作者: pockchop 時間: 2012-10-10 15:14
小白問題:分兩個subnet有乜好處?另係米係router度可以分,唔駛係個switch度分?
作者: vc2010 時間: 2012-10-11 20:01
http://forums.whirlpool.net.au/archive/1602975
作者: pockchop 時間: 2012-10-11 20:53
明明地棘,師兄果然勁,師兄用邊隻router?相信都係好野黎,係米Policy-based?講番switch,其實係米你個router行唔到giga你先要係個switch個度唸計?
作者: karateken 時間: 2012-10-12 11:51
屋企用
諗住Network分開兩組管理(一組 set 晒192.168.0.xxx for data/ pc, 一組 set 晒10.0.0.xxx for st ...
vc2010 發表於 2012-10-9 18:56
家用router 好少可以 Assign IP per port.... 如果你要係街度入你隻NAS, 一係....
1. 你隻NAS有兩個LAN port, 一個用 192.168.0.x for management (Connected to switch / router for internet access), 另一個用10.0.0.x for storage transfer (no internet access, direct connected to your PC);
2. 你要入你屋企隻PC再去隻NAS做management.
In office situation, the storage network (10.x.x.x) separated with data network (192.168.x.x) and the switch need VLAN and configure tuning for storage data transfer to make sure the transfer rate is good..
作者: dtsang29 時間: 2012-10-13 01:23
我用緊tp-link 5 port嗰隻, 平, 係膠啲者

